An Exceptional Quality CNC Machined Version II Motorcycle Switches
Handcrafted with a passion for great functionality and design by Messnermoto in Milan, Italy. The MessnerMoto CNC machined Version II motorcycle switches are slim in a configuration with only 12mm in width, and yet, the buttons are still easily accessible even if your gloves are on.
The Version II switches were specifically designed to be able to conceal the wiring of the switches. This done by cutting a groove into the switch body, which enables you to run the wiring into the bar by drilling a hole into the bar.
The great thing about these switches is that if you want four buttons on one side, you just install 2, two button switches side by side. If you want 5 buttons, you simply install a 2 button and a 3 button switch on the same side.
Also with the Version II motorcycle switches by MessnerMoto, the switches can be installed without removing the grips.
Our motorcycle switches are specially manufactured with 6061-T6 billet aluminum using the CNC machining process to have a clean and smooth line—the buttons are miniature momentary IP65 rating at 1amp. The MessnerMoto three-button switches are for 22mm (7/8″) handlebars and the wires exit to the controls on the side.
Using a laser 3D printed PA12 plastic sleeve that supports the wires strengthens the cable to prevent cable fatigue; on the other hand, you can choose to run the cable inside the handlebar or exit to the side of the switch.
Messnermoto created the motorcycle switches to work with a control module like the M-Unit so you can configure each button to activate a separate circuit. You can also use the three-button bike switch with any available electronic relay.
- Available in Hard-Anodized in Black
- Three IP65 miniature momentary 1A 12mm (M8) buttons
- 45mm in diameter
- 12mm in width
- Designed for 22mm (7/8″) handlebars
- Easily installed without removing grips